NewsWeeZ
17/09/2010, 10:45
GPH has released GP2X Wiz Firmware v. 1.2.6 rev 359 (this firmware it’s only for GP2X Wiz).
Cautions
-*Never use this firmware into other devices. If there are any services to be done there will be charges for the AS.
-*If there is anything saved into your NAND please back up.
-*After updating firmware check your touch screen calibration.
.
GP2X Wiz firmware 1.2.6 Information
.
1.*Performance Improvement
A.*Clock Settings
B.*SD Card in/out adjustment
2.*Function Addition
A.*WiFi connection
How to upgrade Firmware
.
1.*Copy Paste the firmware file into your SD Card
A.*Warning : Make sure your SD Card is above 1GB.
2.*Insert SD Card and press R Button and turn on your device for upgrade.
3.*Release the R Button when Firmware upgrade screen appears.
.4.*It takes 15 min for upgrade.
.5.*If firmware has been properly updated then reboot it. Set value of touch panel is initialized by the update therefore revise the setting value of touch panel in environment setting.
6.*If you see following message, try it again by switching off and on. If you still have the same problem then try it again by replacing SD card..
7.*If all completed, delete those files copied to SD memory.
.
If battery discharges during upgrading firmware, it may cause damage to product. Therefore battery must be fully charged or secure stable electric power using USB cable before start to upgrade firmware.
. Some pictures on the screen may be broken during patching firmware.
It will output normally after completion of patching.
Download Wiz Firmware v. 1.2.6 (http://www.fungp.com/download/GP2XWiz_Firmware_v1.2.6_rev359_20100915.zip)
http://lostsite.altervista.org/wiz/wp-content/uploads/firmware01_eng.png
Source (http://www.fungp.com/)
Más información... (http://lostsite.altervista.org/wiz/?p=2244)
Cautions
-*Never use this firmware into other devices. If there are any services to be done there will be charges for the AS.
-*If there is anything saved into your NAND please back up.
-*After updating firmware check your touch screen calibration.
.
GP2X Wiz firmware 1.2.6 Information
.
1.*Performance Improvement
A.*Clock Settings
B.*SD Card in/out adjustment
2.*Function Addition
A.*WiFi connection
How to upgrade Firmware
.
1.*Copy Paste the firmware file into your SD Card
A.*Warning : Make sure your SD Card is above 1GB.
2.*Insert SD Card and press R Button and turn on your device for upgrade.
3.*Release the R Button when Firmware upgrade screen appears.
.4.*It takes 15 min for upgrade.
.5.*If firmware has been properly updated then reboot it. Set value of touch panel is initialized by the update therefore revise the setting value of touch panel in environment setting.
6.*If you see following message, try it again by switching off and on. If you still have the same problem then try it again by replacing SD card..
7.*If all completed, delete those files copied to SD memory.
.
If battery discharges during upgrading firmware, it may cause damage to product. Therefore battery must be fully charged or secure stable electric power using USB cable before start to upgrade firmware.
. Some pictures on the screen may be broken during patching firmware.
It will output normally after completion of patching.
Download Wiz Firmware v. 1.2.6 (http://www.fungp.com/download/GP2XWiz_Firmware_v1.2.6_rev359_20100915.zip)
http://lostsite.altervista.org/wiz/wp-content/uploads/firmware01_eng.png
Source (http://www.fungp.com/)
Más información... (http://lostsite.altervista.org/wiz/?p=2244)