como se instalan los firwares??

[GammaRay]

pues basicamente eso, queria saber como se instalan los firm de esta consola, porque no he encontrado ni un manual que diga como se hace y es algo que me gustaria aprender a hacer os agradeceria si me decis el procedimiento para hacer esto, gracias!!

[NEKRO]

En el readme del propio firm viene bastante clarito:


BEFORE DOING ANYTHING:
1. Remove memory card if inserted. ( precaution )
2. Make sure that the battery is fully charged.
3. Backup up all files from the internal storage as these are deleted in the process.

INSTALLING THE USB DRIVER IN WINDOWS VISTA:
1. Put the Dingoo a-320 is USB mode by pressing and holding the B button while inserting a pin or similar into the reset hole
2. Conect the USB cable between your computer and Dingoo
3. Now you need to install the windows USB driver for JZ4740 USB Boot device. Click "Locate and install driver software"
4. Click on "I don't have the disc. Show me other options"
5. Click on "Browse my computer for driver software".
6. Browse to where you extracted the files and choose "Next".
7. Accept the security warning by clicking "Install this driver software anyway"
8. The driver should now install and a final confirmation screen should pop up informing you that the driver was successfully installed as "Chinachip USB loader". Click "Close"

FLASHING PROCESS:
1. Run "flashutil.exe" as administrator by right clicking the file and choose "Run as administrator".
2. Click the "Select" button in the "System DL Config" field and choose "A320_PD27_ILI9325_RLS.dl"or "CCPMP_CFG_A320_LCM_FAIR_ILI9331_320_240.DL" for the newer dingoos.
3. Click the "Select" button in the "Firmware file" field and choose "a320-1.03TD-3.hxf". This is the file i have edited.
4. Click the "Burning System" button to start the flashing process.
5. 3 text lines should appear and a "Firmware upgrade" screen should show on your Dingoo. This process could take a couple of minutes.
6. A fourth text line should appear, confirming that the flashing process is complete. Now exit the program.
7. Disconnect the USB cable. The dingoo will now reset and reboot. It will not start up as usual because of the missing system files.

REPLACING THE SYSTEM FILES:
1. Connect the USB cable again.
2. Reset the Dingoo by inserting a pin or similar into the reset hole
3. After a couple of seconds the Dingoo comes up as a physical drive. Open the drive.
4. Copy the contents of the 'ROOT FILES' directory into the root directory ( the same location as GAME, PICURE, RECORD etc )
5. Reset the Dingoo again by inserting a pin or similar into the reset hole

You are done. The Dingoo should boot up as normal.

[GammaRay]

el firm que me baje no tenia readme xD, gracias por pegarmelo

< - >
mmm tengo otra preguntilla pero aprovecho este post, hay alguna forma de resetear la dingoo completamente, dejarla como recien comprada sin las roms metidas ni el dingux?

[Fistro]

Me ha llegado hoy la Dingoo y tiene el firm 1.11 dice que es de finales de julio del 2009, se supone que es la ultima version.

[dj syto]

Me ha llegado hoy la Dingoo y tiene el firm 1.11 dice que es de finales de julio del 2009, se supone que es la ultima version.

vaya.

[tusksegundo]

Dale al botón que pone "instalar firm" supongo que habrá uno que ponga esto...