DCEmu.co.uk
24/01/2009, 22:30
A new release for the Wiz from Orkie (http://www.gp32x.com/board/index.php?showtopic=45760)
Was messing around earlier. Here is a package of stuff you need to get started developing for the Wiz under Linux. It is derived from the Open2x stuff. Copy the config file as .config into a crosstool-ng 1.2.4 setup and build the toolchain with that. Then run the library build script.
It isn't very well tested yet, but if your stuff builds with this it will probably work on an OpenWiz firmware (I will be using the libs compiled in this way). I might post up some raw hardware code at some point soon too.
http://x11.gp2x.de/openwiz/openwiz-t...161208.tar.bz2 (http://x11.gp2x.de/openwiz/openwiz-toolchain-161208.tar.bz2)
Download and Give Feedback Via Comments
thanks to pdroms (http://pdroms.com) for news.
Más información... (http://www.dcemu.co.uk/vbulletin/showthread.php?t=181278&goto=newpost)
Was messing around earlier. Here is a package of stuff you need to get started developing for the Wiz under Linux. It is derived from the Open2x stuff. Copy the config file as .config into a crosstool-ng 1.2.4 setup and build the toolchain with that. Then run the library build script.
It isn't very well tested yet, but if your stuff builds with this it will probably work on an OpenWiz firmware (I will be using the libs compiled in this way). I might post up some raw hardware code at some point soon too.
http://x11.gp2x.de/openwiz/openwiz-t...161208.tar.bz2 (http://x11.gp2x.de/openwiz/openwiz-toolchain-161208.tar.bz2)
Download and Give Feedback Via Comments
thanks to pdroms (http://pdroms.com) for news.
Más información... (http://www.dcemu.co.uk/vbulletin/showthread.php?t=181278&goto=newpost)